How to Reset Ink Absorber on Canon E484

Canon E484 Ink Absorber Full Reset

If your Canon E484 suddenly refuses to print and shows a maintenance or service warning, the ink absorber counter may have reached its limit.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon E484. Service mode instructions are shown only when a matching series procedure is known.

Finalize the Reset and Restore Printing

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Warnings

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

If It Doesn’t Work

Repeat the service mode steps carefully (timing matters).
Power-cycle the printer and try again.
Close other Canon printer utilities while resetting.
Use the correct Stop/Reset press count for your series.
Try a different USB cable/port if using PC software.

Frequently Asked Questions

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

How long does it take?

Usually a few minutes once the correct steps are followed.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Guide prepared for Canon E484 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.