How to Reset Ink Absorber on Canon E481

Canon E481 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon E481 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon E481. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

‘Ink Absorber Full’ / ‘Service Required’ message
Support/service code (varies by series)
Printing blocked after cleaning cycles
Reset required to continue printing

Finalize the Reset and Restore Printing

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Warnings

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

Troubleshooting

Repeat the service mode steps carefully (timing matters).
Try a different USB cable/port if using PC software.
Power-cycle the printer and try again.
Close other Canon printer utilities while resetting.
Use the correct Stop/Reset press count for your series.

FAQ

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

How long does it take?

Usually a few minutes once the correct steps are followed.

Guide prepared for Canon E481 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.