Epson ET-2721 Waste Ink Counter Reset
If your Epson ET-2721 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.
During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2721 uses a software counter to estimate pad saturation and locks printing at a set threshold.
What Causes the Epson ET-2721 Ink Pad Counter Warning?
A service visit is often unnecessary. Wic Reset Connect allows a safe Epson ET-2721 waste counter reset in minutes.
How the Error Appears
- ‘Service Required’ / service life message in driver or utility
- Maintenance/support code (varies by model/driver)
- Printing stops after cleaning cycles
- Warning repeats after restarting the printer
Three Steps to Restore Epson ET-2721 Printing
- Stap 1: Connect Epson ET-2721 to a Windows computer with a stable Internet connection using a USB cable.
- Stap 2: Run Wic Reset Connect as Administrator and confirm Epson ET-2721 is detected.
- Stap 3: Use the key to reset the counter, wait for completion, then restart Epson ET-2721 to finalize.
Most Epson ET-2721 waste counter resets finish in ~1–2 minutes.
What You Need
- Stable Internet connection during reset
- USB connection required (Wi-Fi reset not supported)
- Windows 7/8/10/11 PC
- Valid Wic Reset Connect reset key
Troubleshooting
- Close Epson Status Monitor or other printer utilities.
- Temporarily disable VPN/proxy if validation fails.
- Restart printer and PC, then try again.
- Run the app as Administrator.
- Try another USB cable (some cables are charge-only).
FAQ
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Guide prepared for Epson ET-2721 – Waste Ink Counter Reset using Wic Reset Connect.