Model-specific reset guide
Canon G4700 Ink Absorber Full Reset
An absorber warning on Canon G4700 does not necessarily mean that the printer is mechanically damaged. The software counter and the physical pads must be considered separately.
Why Canon G4700 reports an absorber error
Waste ink is routed away from the print head and retained inside the printer. The firmware in Canon G4700 calculates usage and may stop new jobs to reduce overflow risk.
Wic Reset Connect is designed to reset the compatible counter in Canon G4700. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G4700
- Turn the printer off.
- Houd ingedrukt Stoppen/terugstellen.
- Terwijl u Stop/Reset ingedrukt houdt, houdt u Stroom.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 keer.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G4700
Work through the sequence without rushing. Incorrect button timing or a blinking power light means the printer is not ready for the counter reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G4700 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G4700 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Connect Canon G4700 directly to the computer and try another data-capable USB cable or port.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
Canon G4700 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does Canon G4700 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Hoe vaak moet ik op Stop/Reset drukken?
For Canon G4700, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon G4700
Complete the Canon G4700 absorber counter reset in a few carefully prepared steps.