Epson XP-221 Waste Ink Counter Reset

When the Epson XP-221 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson XP-221 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

What Causes the Epson XP-221 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson XP-221 waste counter reset in minutes.

Common Symptoms

‘Service Required’ / service life message in driver or utility
Maintenance/support code (varies by model/driver)
Printing stops after cleaning cycles
Warning repeats after restarting the printer

Reset Epson XP-221 Waste Ink Counter in 3 Steps

Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson XP-221 via USB (Wi-Fi reset is not supported).
Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson XP-221 appears in the device list.
Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson XP-221.

Buy Reset Key ⬇️ Download Wic Reset Connect 使用方法

Most Epson XP-221 waste counter resets finish in ~1–2 minutes.

Before You Begin

Valid Wic Reset Connect reset key
Windows 7/8/10/11 PC
Stable Internet connection during reset
USB connection required (Wi-Fi reset not supported)

FAQ

How long does it take?

Usually about 1–2 minutes.

What if reset doesn’t work?

Check USB cable/port, run as admin, and close other printer utilities.

Do I need a service center?

Typically not for a waste ink counter lock; a reset is usually sufficient.

Can I reset over Wi-Fi?

No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson XP-221 – Waste Ink Counter Reset using Wic Reset Connect.