Model-specific reset guide
Canon TS9040 Ink Absorber Full Reset
Canon TS9040 can stop printing when its internal ink absorber counter reaches a programmed threshold. Follow the model-specific preparation below before using Wic Reset Connect.
The waste ink counter inside Canon TS9040
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon TS9040. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS9040
- Turn the printer off.
- を押し続ける ストップ/リセット.
- ストップ/リセットを押しながら、 を押し続けます。 パワー.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5回.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS9040
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS9040 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS9040 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon TS9040 directly to the computer and try another data-capable USB cable or port.
Canon TS9040 reset FAQ
ストップ/リセットを何回押せばいいですか？
For Canon TS9040, use 5 Stop/Reset presses in the sequence shown on this page.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does Canon TS9040 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon TS9040
Ready to reset Canon TS9040? Verify the power light, USB connection and service-mode state before continuing.