Model-specific reset guide
Canon MG5400 インク吸収剤の完全リセット
An absorber warning on Canon MG5400 does not necessarily mean that the printer is mechanically damaged. The software counter and the physical pads must be considered separately.
The waste ink counter inside Canon MG5400
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon MG5400. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG5400
- Turn the printer off.
- を押し続ける ストップ/リセット.
- ストップ/リセットを押しながら、 を押し続けます。 パワー.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6回.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG5400
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG5400 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG5400 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Connect Canon MG5400 directly to the computer and try another data-capable USB cable or port.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon MG5400 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does Canon MG5400 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon MG5400
Complete the Canon MG5400 absorber counter reset in a few carefully prepared steps.