Model-specific reset guide
Canon G7045 Ink Absorber Full Reset
When Canon G7045 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
The waste ink counter inside Canon G7045
Waste ink is routed away from the print head and retained inside the printer. The firmware in Canon G7045 calculates usage and may stop new jobs to reduce overflow risk.
Wic Reset Connect is designed to reset the compatible counter in Canon G7045. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G7045
- Turn the printer off.
- を押し続ける ストップ/リセット.
- ストップ/リセットを押しながら、 を押し続けます。 パワー.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5回.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G7045
The counter reset normally takes only a few minutes after Canon G7045 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G7045 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G7045 is not detected
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon G7045 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
ストップ/リセットを何回押せばいいですか？
For Canon G7045, use 5 Stop/Reset presses in the sequence shown on this page.
Does Canon G7045 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon G7045
Use the correct sequence for Canon G7045 and restore printing without an unnecessary service visit.