Epson TX119 Waste Ink Counter Reset

When the Epson TX119 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson TX119 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson TX119 Stops Printing (Waste Counter Limit)

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson TX119 waste counter reset in minutes.

How the Error Appears

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Reset Epson TX119 Waste Ink Counter in 3 Steps

1. Fase 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX119 via USB (Wi-Fi reset is not supported).
2. Fase 2: Start Wic Reset Connect in Administrator mode and wait until Epson TX119 appears in the device list.
3. Fase 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson TX119.

Most Epson TX119 waste counter resets finish in ~1–2 minutes.

System Requirements

• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset

Common Fixes

• Run the app as Administrator.
• Temporarily disable VPN/proxy if validation fails.
• Try another USB cable (some cables are charge-only).
• Restart printer and PC, then try again.
• Use a direct USB connection (avoid hubs).

Frequently Asked Questions