How to Reset Epson RX615 Waste Ink Counter

Epson RX615 Waste Ink Counter Reset

When the Epson RX615 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson RX615 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson RX615 Show ‘Service Required’?

With Wic Reset Connect, you can reset the Epson RX615 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Epson RX615 Ink Pad Counter Reset – Quick Steps

  1. Fase 1: Prepare a Windows PC + USB cable and connect Epson RX615 directly. Keep Internet enabled for validation.
  2. Fase 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson RX615.
  3. Fase 3: Paste the reset key, click Reset, and after completion power-cycle Epson RX615.
Buy Reset Key ⬇️ Download Wic Reset Connect Istruzioni

Most Epson RX615 waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

  • Use a direct USB connection (avoid hubs).
  • Temporarily disable VPN/proxy if validation fails.
  • Restart printer and PC, then try again.
  • Run the app as Administrator.
  • Try another USB cable (some cables are charge-only).

FAQ

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson RX615 – Waste Ink Counter Reset using Wic Reset Connect.

Carrello della spesa