Model-specific reset guide
Reset completo dell'assorbitore d'inchiostro della Canon TS3327
An absorber warning on Canon TS3327 does not necessarily mean that the printer is mechanically damaged. The software counter and the physical pads must be considered separately.
What the Canon TS3327 service message means
Canon TS3327 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon TS3327. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS3327
- Turn the printer off.
- Tenere premuto Stop/Reset.
- Tenendo premuto Stop/Reset, premere e tenere premuto Potenza.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 volte.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS3327
The counter reset normally takes only a few minutes after Canon TS3327 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS3327 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS3327 is not detected
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon TS3327 reset FAQ
Quante volte devo premere Stop/Reset?
For Canon TS3327, use 5 Stop/Reset presses in the sequence shown on this page.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Restore Canon TS3327
Follow the verified steps for Canon TS3327, then restart the printer and return to normal operation.