Model-specific reset guide
Canon MG6890 Ink Absorber Full Reset
Canon MG6890 can stop printing when its internal ink absorber counter reaches a programmed threshold. Follow the model-specific preparation below before using Wic Reset Connect.
What the Canon MG6890 service message means
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon MG6890. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG6890
- Turn the printer off.
- Tenere premuto Stop/Reset.
- Tenendo premuto Stop/Reset, premere e tenere premuto Potenza.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 volte.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG6890
Service mode must be entered correctly before Wic Reset Connect can communicate with the maintenance interface. Resolve other printer errors first.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG6890 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG6890 is not detected
- Connect Canon MG6890 directly to the computer and try another data-capable USB cable or port.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon MG6890 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does Canon MG6890 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Restore Canon MG6890
Complete the Canon MG6890 absorber counter reset in a few carefully prepared steps.