Model-specific reset guide
Canon TS9510 Ink Absorber Full Reset
Canon TS9510 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
The waste ink counter inside Canon TS9510
Canon TS9510 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon TS9510. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS9510
- Turn the printer off.
- Nyomja meg és tartsa lenyomva Megállítás/visszaállítás.
- Miközben lenyomva tartja a Stop/Reset gombot, nyomja meg és tartsa lenyomva Teljesítmény.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 alkalommal.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS9510
The counter reset normally takes only a few minutes after Canon TS9510 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS9510 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS9510 is not detected
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Connect Canon TS9510 directly to the computer and try another data-capable USB cable or port.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon TS9510 reset FAQ
Does Canon TS9510 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Hányszor kell megnyomni a Stop/Reset gombot?
For Canon TS9510, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon TS9510
Prepare Canon TS9510, enter service mode and complete the reset with a valid Wic Reset Connect key.