Model-specific reset guide
Canon MX868 tintaszívó teljes visszaállítás
When Canon MX868 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
What stops Canon MX868 from printing
Canon MX868 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon MX868. The physical waste ink system should still be inspected and maintained when necessary.
Enter service mode on Canon MX868
The Stop/Reset press count varies across Canon series. Use the complete service-mode guide and select the procedure for this printer instead of guessing.
Reset the counter in Canon MX868
The counter reset normally takes only a few minutes after Canon MX868 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the linked guide.
-
Connect directly by USB
Connect Canon MX868 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MX868 is not detected
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Connect Canon MX868 directly to the computer and try another data-capable USB cable or port.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
Canon MX868 reset FAQ
Does Canon MX868 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Restore Canon MX868
Ready to reset Canon MX868? Verify the power light, USB connection and service-mode state before continuing.