Model-specific reset guide
Canon MG3200 tintaszívó teljes visszaállítás
The waste ink system in Canon MG3200 collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.
Understanding the Canon MG3200 ink absorber warning
The lock is based on accumulated maintenance activity. Resetting Canon MG3200 changes the counter value but does not remove ink already held in the absorber material.
Wic Reset Connect is designed to reset the compatible counter in Canon MG3200. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG3200
- Turn the printer off.
- Nyomja meg és tartsa lenyomva Megállítás/visszaállítás.
- Miközben lenyomva tartja a Stop/Reset gombot, nyomja meg és tartsa lenyomva Teljesítmény.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 alkalommal.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG3200
Work through the sequence without rushing. Incorrect button timing or a blinking power light means the printer is not ready for the counter reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG3200 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG3200 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Connect Canon MG3200 directly to the computer and try another data-capable USB cable or port.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
Canon MG3200 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Hányszor kell megnyomni a Stop/Reset gombot?
For Canon MG3200, use 6 Stop/Reset presses in the sequence shown on this page.
Restore Canon MG3200
Use the correct sequence for Canon MG3200 and restore printing without an unnecessary service visit.