Epson K200 Waste Ink Counter Reset

When the Epson K200 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson K200 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson K200 Show ‘Service Required’?

Most Epson K200 waste ink counter locks are solved by a software counter reset. Wic Reset Connect Pruža jednostavan postupak.

Kako se pogreška prikazuje

• Pisač odbija ispisati čak i kad je tinte dovoljno.
• Epson Status Monitor prikazuje upozorenje na održavanje
• Treptajuća svjetla i blokirani poslovi
• Uređaj je zaključan dok se ne izvrši resetiranje.

Reset Epson K200 Waste Ink Counter in 3 Steps

1. Korak 1: Prepare a Windows PC + USB cable and connect Epson K200 directly. Keep Internet enabled for validation.
2. Korak 2: Otvoreno Wic Reset Connect with admin privileges and verify device recognition for Epson K200.
3. Korak 3: Umetnite reset-ključ i kliknite Ponovno pokretanje, and after completion power-cycle Epson K200.

Most Epson K200 waste counter resets finish in ~1–2 minutes.

Ako se pisač ne detektira

• Ponovno pokrenite pisač i računalo, zatim pokušajte ponovno.
• Zatvorite Epson Status Monitor ili druge uslužne programe za pisač.
• Isprobajte drugi USB kabel (neki kabeli služe samo za punjenje).
• Koristite izravno USB-povezivanje (izbjegavajte USB-hubove).
• Pokrenite aplikaciju kao administrator.