Epson K200 Waste Ink Counter Reset

When the Epson K200 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson K200 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson K200 Show ‘Service Required’?

Most Epson K200 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Reset Epson K200 Waste Ink Counter in 3 Steps

1. Step 1: Prepare a Windows PC + USB cable and connect Epson K200 directly. Keep Internet enabled for validation.
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson K200.
3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson K200.

Most Epson K200 waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

• Restart printer and PC, then try again.
• Close Epson Status Monitor or other printer utilities.
• Try another USB cable (some cables are charge-only).
• Use a direct USB connection (avoid hubs).
• Run the app as Administrator.