Epson WorkForce 60 Waste Ink Counter Reset
The Epson WorkForce 60 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.
The Epson WorkForce 60 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.
What Causes the Epson WorkForce 60 Ink Pad Counter Warning?
With Wic Reset Connect, you can reset the Epson WorkForce 60 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.
How the Error Appears
- Printer refuses to print even with ink available
- Epson Status Monitor shows maintenance warning
- Blinking lights and blocked jobs
- Device is locked until reset is performed
Epson WorkForce 60 Ink Pad Counter Reset – Quick Steps
- Étape 1 : Prepare a Windows PC + USB cable and connect Epson WorkForce 60 directly. Keep Internet enabled for validation.
- Étape 2 : Run Wic Reset Connect as Administrator and confirm Epson WorkForce 60 is detected.
- Étape 3 : Use the key to reset the counter, wait for completion, then restart Epson WorkForce 60 to finalize.
Most Epson WorkForce 60 waste counter resets finish in ~1–2 minutes.
Common Fixes
- Use a direct USB connection (avoid hubs).
- Close Epson Status Monitor or other printer utilities.
- Try another USB cable (some cables are charge-only).
- Run the app as Administrator.
- Temporarily disable VPN/proxy if validation fails.
FAQ
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
Guide prepared for Epson WorkForce 60 – Waste Ink Counter Reset using Wic Reset Connect.