Fix Epson ME-570W Service Required – Waste Counter Reset

Epson ME-570W Waste Ink Counter Reset

When the Epson ME-570W reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson ME-570W tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson ME-570W Waste Ink Counter

Most Epson ME-570W waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Epson ME-570W Ink Pad Counter Reset – Quick Steps

  1. Étape 1 : Prepare a Windows PC + USB cable and connect Epson ME-570W directly. Keep Internet enabled for validation.
  2. Étape 2 : Run Wic Reset Connect as Administrator and confirm Epson ME-570W is detected.
  3. Étape 3 : Paste the reset key, click Reset, and after completion power-cycle Epson ME-570W.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson ME-570W waste counter resets finish in ~1–2 minutes.

Troubleshooting

  • Try another USB cable (some cables are charge-only).
  • Close Epson Status Monitor or other printer utilities.
  • Use a direct USB connection (avoid hubs).
  • Temporarily disable VPN/proxy if validation fails.
  • Run the app as Administrator.

FAQ

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson ME-570W – Waste Ink Counter Reset using Wic Reset Connect.

Panier