Epson ME-570W Waste Ink Counter Reset

When the Epson ME-570W reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson ME-570W tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson ME-570W Waste Ink Counter

Most Epson ME-570W waste ink counter locks are solved by a software counter reset. Wic Reset Connect giver en ligetil procedure.

Hvordan fejlen opstår

• ‘Service påkrævet’/meddelelse om levetid i driver eller hjælpeprogram
• Vedligeholdelses-/supportkode (varierer efter model/driver)
• Udskrivning stopper efter rengøringscyklusser
• Advarslen gentages efter genstart af printeren

Epson ME-570W Ink Pad Counter Reset – Quick Steps

1. Trin 1: Prepare a Windows PC + USB cable and connect Epson ME-570W directly. Keep Internet enabled for validation.
2. Trin 2: Løb Wic Reset Connect as Administrator and confirm Epson ME-570W is detected.
3. Trin 3: Indsæt nulstillingsnøglen, klik på Nulstil, and after completion power-cycle Epson ME-570W.

Most Epson ME-570W waste counter resets finish in ~1–2 minutes.

Fejlfinding

• Prøv et andet USB-kabel (nogle kabler er kun til opladning).
• Luk Epson Status Monitor eller andre printerværktøjer.
• Brug en direkte USB-forbindelse (undgå hubs).
• Deaktiver midlertidigt VPN/proxy, hvis valideringen mislykkes.
• Kør appen som administrator.

OFTE STILLEDE SPØRGSMÅL