Fix Epson ET-2610 Service Required – Waste Counter Reset

Epson ET-2610 Waste Ink Counter Reset

When the Epson ET-2610 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2610 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson ET-2610 Ink Pad Counter Warning?

Most Epson ET-2610 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Epson ET-2610 Ink Pad Counter Reset – Quick Steps

  1. Étape 1 : Prepare a Windows PC + USB cable and connect Epson ET-2610 directly. Keep Internet enabled for validation.
  2. Étape 2 : Run Wic Reset Connect as Administrator and confirm Epson ET-2610 is detected.
  3. Étape 3 : Paste the reset key, click Reset, and after completion power-cycle Epson ET-2610.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson ET-2610 waste counter resets finish in ~1–2 minutes.

Before You Begin

  • Stable Internet connection during reset
  • Windows 7/8/10/11 PC
  • Valid Wic Reset Connect reset key
  • USB connection required (Wi-Fi reset not supported)

Frequently Asked Questions

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson ET-2610 – Waste Ink Counter Reset using Wic Reset Connect.

Panier