Model-specific reset guide
Canon MG5722 Ink Absorber Full Reset
Canon MG5722 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Before resetting Canon MG5722
Canon MG5722 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon MG5722. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG5722
- Turn the printer off.
- Vajutage ja hoidke all Stopp/tagasi seadistamine.
- Hoidke Stop/Reset all, vajutage ja hoidke all Võimsus.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 korda.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG5722
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG5722 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG5722 is not detected
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
Canon MG5722 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does Canon MG5722 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon MG5722
Follow the verified steps for Canon MG5722, then restart the printer and return to normal operation.