Model-specific reset guide
Canon MG4140 Ink Absorber Full Reset
The waste ink system in Canon MG4140 collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.
Understanding the Canon MG4140 ink absorber warning
Waste ink is routed away from the print head and retained inside the printer. The firmware in Canon MG4140 calculates usage and may stop new jobs to reduce overflow risk.
Wic Reset Connect is designed to reset the compatible counter in Canon MG4140. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG4140
- Turn the printer off.
- Vajutage ja hoidke all Stopp/tagasi seadistamine.
- Hoidke Stop/Reset all, vajutage ja hoidke all Võimsus.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 korda.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG4140
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG4140 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG4140 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
Canon MG4140 reset FAQ
Mitu korda peaksin ma vajutama Stop/Reset?
For Canon MG4140, use 6 Stop/Reset presses in the sequence shown on this page.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Does Canon MG4140 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon MG4140
Use the correct sequence for Canon MG4140 and restore printing without an unnecessary service visit.