Model-specific reset guide
Canon G2915 Ink Absorber Full Reset
If Canon G2915 displays an ink absorber full or service-required warning, the stored waste ink counter may have reached its limit. This guide covers service mode, USB preparation and the reset itself.
Why Canon G2915 reports an absorber error
Canon G2915 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon G2915. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G2915
- Turn the printer off.
- Vajutage ja hoidke all Stopp/tagasi seadistamine.
- Hoidke Stop/Reset all, vajutage ja hoidke all Võimsus.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 korda.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G2915
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G2915 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G2915 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon G2915 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Mitu korda peaksin ma vajutama Stop/Reset?
For Canon G2915, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon G2915
Use the correct sequence for Canon G2915 and restore printing without an unnecessary service visit.