Epson RX590 Waste Ink Counter Reset

When the Epson RX590 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson RX590 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson RX590 Stops Printing (Waste Counter Limit)

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson RX590 waste counter reset in minutes.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Three Steps to Restore Epson RX590 Printing

1. Paso 1: Prepare a Windows PC + USB cable and connect Epson RX590 directly. Keep Internet enabled for validation.
2. Paso 2: Run Wic Reset Connect as Administrator and confirm Epson RX590 is detected.
3. Paso 3: Paste the reset key, click Reset, and after completion power-cycle Epson RX590.

Most Epson RX590 waste counter resets finish in ~1–2 minutes.

What You Need

• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)

Troubleshooting

• Try another USB cable (some cables are charge-only).
• Temporarily disable VPN/proxy if validation fails.
• Run the app as Administrator.
• Restart printer and PC, then try again.
• Close Epson Status Monitor or other printer utilities.

Frequently Asked Questions