Epson PX-1004 Waste Ink Counter Reset

When the Epson PX-1004 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson PX-1004 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Understanding the Epson PX-1004 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson PX-1004 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Reset Epson PX-1004 Waste Ink Counter in 3 Steps

1. Paso 1: Use a Windows PC (7–11) with Internet access. Connect Epson PX-1004 via USB (Wi-Fi reset is not supported).
2. Paso 2: Run Wic Reset Connect as Administrator and confirm Epson PX-1004 is detected.
3. Paso 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson PX-1004.

Most Epson PX-1004 waste counter resets finish in ~1–2 minutes.

Before You Begin

• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key

Common Fixes

• Try another USB cable (some cables are charge-only).
• Run the app as Administrator.
• Restart printer and PC, then try again.
• Close Epson Status Monitor or other printer utilities.
• Use a direct USB connection (avoid hubs).

FAQ