Model-specific reset guide
Canon MG3640S Ink Absorber Full Reset
The waste ink system in Canon MG3640S collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.
Why Canon MG3640S reports an absorber error
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon MG3640S. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG3640S
- Turn the printer off.
- Mantenga pulsado Parar/Restablecer.
- Mientras mantiene pulsado Stop/Reset, pulse y mantenga pulsado Potencia.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 veces.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG3640S
The counter reset normally takes only a few minutes after Canon MG3640S has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG3640S to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG3640S is not detected
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Connect Canon MG3640S directly to the computer and try another data-capable USB cable or port.
Canon MG3640S reset FAQ
Does Canon MG3640S require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
¿Cuántas veces debo pulsar Stop/Reset?
For Canon MG3640S, use 6 Stop/Reset presses in the sequence shown on this page.
Restore Canon MG3640S
Prepare Canon MG3640S, enter service mode and complete the reset with a valid Wic Reset Connect key.