Model-specific reset guide
Canon G3600 Ink Absorber Full Reset
Canon G3600 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Why Canon G3600 reports an absorber error
Waste ink is routed away from the print head and retained inside the printer. The firmware in Canon G3600 calculates usage and may stop new jobs to reduce overflow risk.
Wic Reset Connect is designed to reset the compatible counter in Canon G3600. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G3600
- Turn the printer off.
- Mantenga pulsado Parar/Restablecer.
- Mientras mantiene pulsado Stop/Reset, pulse y mantenga pulsado Potencia.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 veces.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G3600
Prepare Canon G3600 before entering the key. A stable service-mode state and direct USB connection are essential.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G3600 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G3600 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Connect Canon G3600 directly to the computer and try another data-capable USB cable or port.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
Canon G3600 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
¿Cuántas veces debo pulsar Stop/Reset?
For Canon G3600, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon G3600
Prepare Canon G3600, enter service mode and complete the reset with a valid Wic Reset Connect key.