How to Reset Epson TX730WD Waste Ink Counter

Epson TX730WD Waste Ink Counter Reset

When the Epson TX730WD reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson TX730WD accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why Does the Epson TX730WD Show ‘Service Required’?

With Wic Reset Connect, you can reset the Epson TX730WD waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

How the Error Appears

Printer refuses to print even with ink available
Epson Status Monitor shows maintenance warning
Blinking lights and blocked jobs
Device is locked until reset is performed

Step-by-Step: Epson TX730WD Waste Counter Reset

Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX730WD via USB (Wi-Fi reset is not supported).
Step 2: Run Wic Reset Connect as Administrator and confirm Epson TX730WD is detected.
Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson TX730WD.

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson TX730WD waste counter resets finish in ~1–2 minutes.

Troubleshooting

Close Epson Status Monitor or other printer utilities.
Try another USB cable (some cables are charge-only).
Use a direct USB connection (avoid hubs).
Run the app as Administrator.
Temporarily disable VPN/proxy if validation fails.

FAQ

Do I need a service center?

Typically not for a waste ink counter lock; a reset is usually sufficient.

What if reset doesn’t work?

Check USB cable/port, run as admin, and close other printer utilities.

How long does it take?

Usually about 1–2 minutes.

Can I reset over Wi-Fi?

No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson TX730WD – Waste Ink Counter Reset using Wic Reset Connect.