Epson NX430 Waste Ink Counter Reset

If your Epson NX430 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

The Epson NX430 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson NX430 Waste Ink Counter

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson NX430 waste counter reset in minutes.

Typical Signs

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Reset Epson NX430 Waste Ink Counter in 3 Steps

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson NX430 via USB (Wi-Fi reset is not supported).
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson NX430.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson NX430.

Most Epson NX430 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC
• Stable Internet connection during reset

Troubleshooting

• Restart printer and PC, then try again.
• Close Epson Status Monitor or other printer utilities.
• Use a direct USB connection (avoid hubs).
• Run the app as Administrator.
• Try another USB cable (some cables are charge-only).

Frequently Asked Questions