Reset Epson M1129 Waste Ink Counter in Minutes

Epson M1129 Waste Ink Counter Reset

If your Epson M1129 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson M1129 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson M1129 Show ‘Service Required’?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson M1129 waste counter reset in minutes.

Step-by-Step: Epson M1129 Waste Counter Reset

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson M1129 via USB (Wi-Fi reset is not supported).
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson M1129.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson M1129.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson M1129 waste counter resets finish in ~1–2 minutes.

Before You Begin

  • Stable Internet connection during reset
  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key
  • Windows 7/8/10/11 PC

If the Printer Is Not Detected

  • Close Epson Status Monitor or other printer utilities.
  • Use a direct USB connection (avoid hubs).
  • Restart printer and PC, then try again.
  • Run the app as Administrator.
  • Temporarily disable VPN/proxy if validation fails.

Frequently Asked Questions

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson M1129 – Waste Ink Counter Reset using Wic Reset Connect.

Shopping Cart