Canon TS8140 Ink Absorber Reset Without Service Center

Canon TS8140 Ink Absorber Full Reset

Canon TS8140 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

During head cleaning, surplus ink is routed to internal absorber pads. Canon TS8140 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon TS8140. Service mode instructions are shown only when a matching series procedure is known.

How to Enter Service Mode on Canon TS8140

To access maintenance functions, Canon TS8140 may need to be placed in service mode first.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Once the counter is cleared, Canon TS8140 should exit the locked state and printing should resume normally.

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

For best results, avoid rushing button presses—consistent timing matters.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

How long does it take?

Usually a few minutes once the correct steps are followed.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Guide prepared for Canon TS8140 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.