Model-specific reset guide
Canon TS8100 Ink Absorber Full Reset
The waste ink system in Canon TS8100 collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.
Why Canon TS8100 reports an absorber error
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon TS8100. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS8100
- Turn the printer off.
- Press and hold Stop/Reset.
- While holding Stop/Reset, press and hold Power.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 times.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS8100
Prepare Canon TS8100 before entering the key. A stable service-mode state and direct USB connection are essential.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS8100 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS8100 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Connect Canon TS8100 directly to the computer and try another data-capable USB cable or port.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
Canon TS8100 reset FAQ
Does Canon TS8100 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
How many times should I press Stop/Reset?
For Canon TS8100, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon TS8100
Prepare Canon TS8100, enter service mode and complete the reset with a valid Wic Reset Connect key.