Canon TS8053 Ink Absorber Full Reset

When Canon TS8053 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

During head cleaning, surplus ink is routed to internal absorber pads. Canon TS8053 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon TS8053. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon TS8053

If your Canon TS8053 supports service mode reset, follow the steps below before performing the counter reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Clear the Ink Absorber / Waste Ink Counter

Once the counter is cleared, Canon TS8053 should exit the locked state and printing should resume normally.

Important Notes

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Download & get started

If your model does not show a service mode section, it means no matching procedure was found for its series.

Troubleshooting

• Try a different USB cable/port if using PC software.
• Use the correct Stop/Reset press count for your series.
• Close other Canon printer utilities while resetting.
• Repeat the service mode steps carefully (timing matters).
• Power-cycle the printer and try again.

FAQ