Canon TS6251 Ink Absorber Full Reset
The “Ink Absorber Full” / service required message on Canon TS6251 is common after many cleaning cycles. In most cases, a counter reset restores printing.
During head cleaning, surplus ink is routed to internal absorber pads. Canon TS6251 monitors this via a counter and can lock printing at a threshold.
This page is prepared for Canon TS6251. Service mode instructions are shown only when a matching series procedure is known.
How the Error Appears
- Service / maintenance warning on the screen or driver
- Printer refuses to print even with ink available
- Blinking lights and queued jobs fail
- Error reappears after restart
How to Enter Service Mode on Canon TS6251
Some Canon series require entering service mode before the ink absorber counter can be reset.
- Turn the printer OFF.
- Press and hold Stop/Reset.
- While holding Stop/Reset, press and hold Power.
- Release Stop/Reset (keep holding Power).
- Press Stop/Reset 5 times.
- Release Power — the printer should enter service mode.
If it doesn’t work, repeat the sequence carefully. The press count depends on the series.
Clear the Ink Absorber / Waste Ink Counter
After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.
Warnings
Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.
Need a reset solution?
Use a reliable USB connection and follow the steps in order.
If It Doesn’t Work
- Close other Canon printer utilities while resetting.
- Power-cycle the printer and try again.
- Try a different USB cable/port if using PC software.
- Use the correct Stop/Reset press count for your series.
- Repeat the service mode steps carefully (timing matters).
Frequently Asked Questions
Guide prepared for Canon TS6251 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.