Canon MX884 Ink Absorber Full Reset

If your Canon MX884 suddenly refuses to print and shows a maintenance or service warning, the ink absorber counter may have reached its limit.

During head cleaning, surplus ink is routed to internal absorber pads. Canon MX884 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon MX884. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

Clear the Ink Absorber / Waste Ink Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Before You Continue

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Need a reset solution?

Use a reliable USB connection and follow the steps in order.

Common Fixes

• Try a different USB cable/port if using PC software.
• Repeat the service mode steps carefully (timing matters).
• Close other Canon printer utilities while resetting.
• Power-cycle the printer and try again.
• Use the correct Stop/Reset press count for your series.

Frequently Asked Questions