MX494 Printer Reset – Ink Absorber Counter Explained

Canon MX494 Ink Absorber Full Reset

When Canon MX494 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MX494. Service mode instructions are shown only when a matching series procedure is known.

Perform the Waste Ink Counter Reset

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Important Notes

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

If your model does not show a service mode section, it means no matching procedure was found for its series.

Frequently Asked Questions

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

How long does it take?

Usually a few minutes once the correct steps are followed.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

Guide prepared for Canon MX494 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.