Canon MX476 Ink Absorber Reset Without Service Center

Canon MX476 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon MX476 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon MX476. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

‘Ink Absorber Full’ / ‘Service Required’ message
Support/service code (varies by series)
Printing blocked after cleaning cycles
Reset required to continue printing

Perform the Waste Ink Counter Reset

Once the counter is cleared, Canon MX476 should exit the locked state and printing should resume normally.

Maintenance Reminder

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

FAQ

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

How long does it take?

Usually a few minutes once the correct steps are followed.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

Guide prepared for Canon MX476 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.