Canon MP550 Ink Absorber Reset Without Service Center

Canon MP550 Ink Absorber Full Reset

If your Canon MP550 suddenly refuses to print and shows a maintenance or service warning, the ink absorber counter may have reached its limit.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MP550. Service mode instructions are shown only when a matching series procedure is known.

Finalize the Reset and Restore Printing

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Maintenance Reminder

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

Common Fixes

Power-cycle the printer and try again.
Close other Canon printer utilities while resetting.
Try a different USB cable/port if using PC software.
Repeat the service mode steps carefully (timing matters).
Use the correct Stop/Reset press count for your series.

Frequently Asked Questions

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

How long does it take?

Usually a few minutes once the correct steps are followed.

Guide prepared for Canon MP550 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.