Fix Ink Absorber Full Error on Canon MG7750

Canon MG7750 Ink Absorber Full Reset

When Canon MG7750 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MG7750. Service mode instructions are shown only when a matching series procedure is known.

How to Enter Service Mode on Canon MG7750

To access maintenance functions, Canon MG7750 may need to be placed in service mode first.

Turn the printer OFF.
Press and hold Stop/Reset.
While holding Stop/Reset, press and hold Power.
Release Stop/Reset (keep holding Power).
Press Stop/Reset 6 times.
Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Reset the Ink Absorber Counter

Once the counter is cleared, Canon MG7750 should exit the locked state and printing should resume normally.

Warnings

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Need a reset solution?

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

Frequently Asked Questions

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

How long does it take?

Usually a few minutes once the correct steps are followed.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Guide prepared for Canon MG7750 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.