Canon MG5660 Ink Absorber Full Reset

Canon MG5660 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MG5660. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon MG5660

Some Canon series require entering service mode before the ink absorber counter can be reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 6 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Reset the Ink Absorber Counter

Once the counter is cleared, Canon MG5660 should exit the locked state and printing should resume normally.

Before You Continue

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Download & get started

Use a reliable USB connection and follow the steps in order.

Common Fixes

• Use the correct Stop/Reset press count for your series.
• Repeat the service mode steps carefully (timing matters).
• Power-cycle the printer and try again.
• Close other Canon printer utilities while resetting.
• Try a different USB cable/port if using PC software.

FAQ