Model-specific reset guide
Canon MG5650 Ink Absorber Reset
Canon MG5650 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Understanding the Canon MG5650 ink absorber warning
The lock is based on accumulated maintenance activity. Resetting Canon MG5650 changes the counter value but does not remove ink already held in the absorber material.
Wic Reset Connect is designed to reset the compatible counter in Canon MG5650. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG5650
- Turn the printer off.
- Press and hold Stop/Reset.
- While holding Stop/Reset, press and hold Power.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 times.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG5650
Prepare Canon MG5650 before entering the key. A stable service-mode state and direct USB connection are essential.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG5650 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG5650 is not detected
- Connect Canon MG5650 directly to the computer and try another data-capable USB cable or port.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon MG5650 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
How many times should I press Stop/Reset?
For Canon MG5650, use 6 Stop/Reset presses in the sequence shown on this page.
Does Canon MG5650 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon MG5650
Follow the verified steps for Canon MG5650, then restart the printer and return to normal operation.