Canon MG3510 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon MG3510 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MG3510. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon MG3510

If your Canon MG3510 supports service mode reset, follow the steps below before performing the counter reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 6 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Clear the Ink Absorber / Waste Ink Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Warnings

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Download & get started

If your model does not show a service mode section, it means no matching procedure was found for its series.

Troubleshooting

• Use the correct Stop/Reset press count for your series.
• Power-cycle the printer and try again.
• Repeat the service mode steps carefully (timing matters).
• Try a different USB cable/port if using PC software.
• Close other Canon printer utilities while resetting.