Reset Canon MB5360 Waste Ink Counter Easily

Canon MB5360 Ink Absorber Full Reset

When Canon MB5360 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

During head cleaning, surplus ink is routed to internal absorber pads. Canon MB5360 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon MB5360. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

‘Ink Absorber Full’ / ‘Service Required’ message
Support/service code (varies by series)
Printing blocked after cleaning cycles
Reset required to continue printing

Finalize the Reset and Restore Printing

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Warnings

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Need a reset solution?

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

If It Doesn’t Work

Repeat the service mode steps carefully (timing matters).
Try a different USB cable/port if using PC software.
Power-cycle the printer and try again.
Close other Canon printer utilities while resetting.
Use the correct Stop/Reset press count for your series.

FAQ

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

How long does it take?

Usually a few minutes once the correct steps are followed.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Guide prepared for Canon MB5360 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.