Model-specific reset guide
Canon MB2740 Ink Absorber Full Reset
Canon MB2740 can stop printing when its internal ink absorber counter reaches a programmed threshold. Follow the model-specific preparation below before using Wic Reset Connect.
The waste ink counter inside Canon MB2740
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon MB2740. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MB2740
- Turn the printer off.
- Press and hold Stop/Reset.
- While holding Stop/Reset, press and hold Power.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 times.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MB2740
Work through the sequence without rushing. Incorrect button timing or a blinking power light means the printer is not ready for the counter reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MB2740 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MB2740 is not detected
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon MB2740 directly to the computer and try another data-capable USB cable or port.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
Canon MB2740 reset FAQ
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
How many times should I press Stop/Reset?
For Canon MB2740, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon MB2740
Wic Reset Connect combines a guided reset with support if Canon MB2740 does not respond as expected.