iP8750 Ink Absorber Full Reset – Step-by-Step Guide

Canon iP8750 Ink Absorber Full Reset

Canon iP8750 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon iP8750. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

Service / maintenance warning on the screen or driver
Printer refuses to print even with ink available
Blinking lights and queued jobs fail
Error reappears after restart

Clear the Ink Absorber / Waste Ink Counter

Once the counter is cleared, Canon iP8750 should exit the locked state and printing should resume normally.

Before You Continue

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

Common Fixes

Power-cycle the printer and try again.
Repeat the service mode steps carefully (timing matters).
Close other Canon printer utilities while resetting.
Use the correct Stop/Reset press count for your series.
Try a different USB cable/port if using PC software.

FAQ

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

How long does it take?

Usually a few minutes once the correct steps are followed.

Guide prepared for Canon iP8750 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.