Reset Canon iP110 Waste Ink Counter Easily

Canon iP110 Ink Absorber Full Reset

If your Canon iP110 suddenly refuses to print and shows a maintenance or service warning, the ink absorber counter may have reached its limit.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon iP110. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

Service / maintenance warning on the screen or driver
Printer refuses to print even with ink available
Blinking lights and queued jobs fail
Error reappears after restart

Reset the Ink Absorber Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Maintenance Reminder

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

If It Doesn’t Work

Try a different USB cable/port if using PC software.
Power-cycle the printer and try again.
Close other Canon printer utilities while resetting.
Repeat the service mode steps carefully (timing matters).
Use the correct Stop/Reset press count for your series.

FAQ

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

How long does it take?

Usually a few minutes once the correct steps are followed.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

Guide prepared for Canon iP110 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.