Canon G7040 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon G7040 is common after many cleaning cycles. In most cases, a counter reset restores printing.

During head cleaning, surplus ink is routed to internal absorber pads. Canon G7040 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon G7040. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon G7040

Some Canon series require entering service mode before the ink absorber counter can be reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Clear the Ink Absorber / Waste Ink Counter

Once the counter is cleared, Canon G7040 should exit the locked state and printing should resume normally.

Before You Continue

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Need a reset solution?

Use a reliable USB connection and follow the steps in order.

Troubleshooting

• Close other Canon printer utilities while resetting.
• Power-cycle the printer and try again.
• Repeat the service mode steps carefully (timing matters).
• Use the correct Stop/Reset press count for your series.
• Try a different USB cable/port if using PC software.

Frequently Asked Questions