Model-specific reset guide
Canon G5030 Ink Absorber Full Reset
Canon G5030 can stop printing when its internal ink absorber counter reaches a programmed threshold. Follow the model-specific preparation below before using Wic Reset Connect.
What stops Canon G5030 from printing
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon G5030. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G5030
- Turn the printer off.
- Press and hold Stop/Reset.
- While holding Stop/Reset, press and hold Power.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 times.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G5030
Service mode must be entered correctly before Wic Reset Connect can communicate with the maintenance interface. Resolve other printer errors first.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G5030 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G5030 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Connect Canon G5030 directly to the computer and try another data-capable USB cable or port.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon G5030 reset FAQ
How many times should I press Stop/Reset?
For Canon G5030, use 5 Stop/Reset presses in the sequence shown on this page.
Does Canon G5030 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon G5030
Prepare Canon G5030, enter service mode and complete the reset with a valid Wic Reset Connect key.