Model-specific reset guide
Canon G2510 Ink Absorber Full Reset
Canon G2510 can stop printing when its internal ink absorber counter reaches a programmed threshold. Follow the model-specific preparation below before using Wic Reset Connect.
What stops Canon G2510 from printing
Canon G2510 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon G2510. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G2510
- Turn the printer off.
- Press and hold Stop/Reset.
- While holding Stop/Reset, press and hold Power.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 times.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G2510
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G2510 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G2510 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Connect Canon G2510 directly to the computer and try another data-capable USB cable or port.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
Canon G2510 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does Canon G2510 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon G2510
Ready to reset Canon G2510? Verify the power light, USB connection and service-mode state before continuing.